to the right of each field
is used to open a dialog menu of options related to the Specification.
Select the values you want to use in Takeoff. Select OK
to save your selections.Specifications allows you to select the specifications for hangers, insulation, and levels.
The to the right of each field
is used to open a dialog menu of options related to the Specification.
Select the values you want to use in Takeoff. Select OK
to save your selections.
HANGERS:This allows you to select where the hangers will be looked up from for both rectangular, round, and pipe hangers.
INSULATION: These options allow you to set the different insulation options for your items.
Liner: Refers to the insulation used as a liner inside the duct.
Wrap: Your selection here will be the default insulation used to wrap the outside the duct during Takeoff.
Pipe: Insulation used for any pipe taken off in HVAC.
LEVELS: Use the
to select the default levels for when an item is
being taken off.
When you are finished making changes, select OK. If you do not want the changes that were made to be saved, select CANCEL.
Note: The drop-down list under Manage Levels By can be used to select a Level Type to use when managing options (instead of a Section).